AUTONET TV

Straight Ahead (Wheel Alignment)

If every road was straight and smooth, we wouldn't have to worry much about wheel alignment. But they're not, so we do.  Hitting potholes or driving on rough pavement can knock your vehicle out of alignment and you'll notice it in one of several ways.

Your steering wheel may not be centered when you're driving straight ahead, or your vehicle may pull to one side.  You may find your tires wearing on one side or they may squeal.  All are signs that could point to you needing an alignment.

Your wheels should be perpendicular to the road and parallel with each other.  If not, your tires will wear out faster and your vehicle won't go straight on a level straightaway.

In alignment, there are several factors that must be checked.  One is camber.  Your wheels should be straight up and down if you look at them from the front. If not, you'll wear your tires unevenly on one side.

Another factor is caster, the angle of the steering pivot.  Most vehicles have what's called positive caster, when the top of the steering pivot leans toward the rear.  Proper caster balances steering effort, stability on the highway and cornering.

You may have heard the term "toe" in reference to your wheels.  If you looked at your front wheels from straight above, for example, imagine your wheels were your feet.  If you were to turn your toes in toward each other, that would be toeing in.  The toe of your vehicle should be set to manufacturer's specifications so your vehicle handles well and doesn't prematurely wear out tires.

It's a good idea to have your alignment checked periodically since it can get knocked out by one hard knock or a lot of little knocks.  It's not just about tire wear, it's about ride comfort and safe handling. You may say a vehicle aligned just feels divine.

High-Tech Auto and Truck Center
4007 Westfax Drive
Chantilly, VA 20151
7039686648
http://high-tech-auto.com

It's Brake Time (Brake Calipers)

Race car drivers have demonstrated the advantages of disc brakes, so most modern vehicles use them.  Sometimes just the front wheels have disc brakes, but many vehicles now have them all the way around. 

A major component of the disc brake is called a caliper.  It works by squeezing brake pads against the disc or rotor, kind of like a bicycle hand brake.  The brake pads themselves are what contact the rotor, causing friction to build and the wheel to slow down, but it's the calipers that apply the pressure to the pads.

Caliper design has evolved over the years, and there are two common types.  One is called a floating caliper.  It has one or two pistons on one side of the disc. When you push down the brake pedal, the piston or pistons in your caliper put pressure on that one side.  A mechanism connected on the other side of the disc applies pressure as well, squeezing your disc so the vehicle stops.  Floating calipers are less expensive since they have fewer parts.

The other type is called a fixed caliper.  They use pistons on both sides of the disc, sometimes several.  They are often used in more high-performance or heavy-duty vehicles.

Calipers can have rubber seals to keep out dirt, debris and moisture, but when that rubber wears out, sometimes the calipers can get contaminated.  They can stick or start leaking; they can even rust.  Then your caliper can get stuck applying that "squeeze" when you are not pressing on the brake pedal.  Or they can get stuck in the other position, not applying stopping power when you press the pedal.

When this happens, it's not unusual to feel your vehicle pull to one side when you brake.  You might notice a burning smell from the constant friction if the caliper is stuck on, plus you may feel the heat from the wheel after you park and get out of your vehicle.  Sometimes you'll hear a high-pitched sound or clunk if your calipers are binding up. 

That's your cue to have them checked out at your vehicle service center.  If your calipers aren't working correctly, it can be a safety hazard.  Sticking calipers can affect your ability to steer and stop; this is the kind of "brake time" you need so you can get them back on track and working properly.

High-Tech Auto and Truck Center
4007 Westfax Drive
Chantilly, VA 20151
7039686648
http://high-tech-auto.com

Why did my vehicle fail its emissions test?

We all want to breathe clean air and keep our planet green.  One of the ways to do that is by requiring all vehicles with internal combustion engines to pass an emissions test.  That’s because these vehicles can be big polluters.  

Everyone wants their car to pass the test so they can continue their day-to-day driving routine.  But then comes that one day when they tell you your vehicle has failed.  Why does that happen?

One of the most common reasons is that your gas cap is leaking or loose (or maybe you don’t even have one on your vehicle!).  The gas cap is supposed to seal in vapors, but sometimes its seals or gaskets dry out or crack. Replace it, and you’re good to go.

Another common reason your vehicle failed the test is that your catalytic converter isn’t doing its job. It is supposed to convert toxic gases from your engine into ones that don’t pollute the air.  There are many reasons the catalytic converter may not be working.  It may be physically damaged, or the steady flow of exhaust gases has fouled the converter. 

You may have a bad oxygen sensor. It’s supposed to measure how much oxygen is in your exhaust.  This can cause the air-fuel mixture to be too rich, resulting in too many hydrocarbons in the exhaust. Your ignition system may also have problems, such as worn-out spark plugs.  Dirty fuel injectors can contribute to excess emissions.

Believe it or not, a dirty engine air filter may be the culprit. If it hasn’t been replaced for a while, your vehicle may be emitting too many hydrocarbons -  something that will cause your vehicle to fail the emissions test.

You can usually avoid a failed emissions test by maintaining your vehicle regularly.  The best way to do that is by bringing it to our trained technicians, so your vehicle gets the service it needs, scheduled and non-scheduled.  Plus, you’ll be doing your part to keep our air clean.

High-Tech Auto and Truck Center
4007 Westfax Drive
Chantilly, VA 20151
7039686648
http://high-tech-auto.com

Flat Tire? Three?s the Charm (Tire Repair)

For most drivers, at some point you’re going to have a flat tire. Depending on how it was damaged, it may have to be replaced.  But sometimes, a repair will do the trick, as long as the puncture isn’t on the sidewall and the hole is smaller than ¼ inch/6.35mm in diameter. Here are the three common ways your tire can be fixed.

One way is to put a plug in the hole.  Since most tires are damaged by running over sharp objects such as screws and nails, the small hole from which the air is escaping is on the part of the tire that touches the road. If it’s in the sidewall, it most likely can’t be fixed.  

In the plug method, a technician inserets a rubber plug.  It is covered with some sticky, gluey stuff, and is pushed into the hole from the outside. That plugs the hole and stays in place, thanks to the glue. Friction from driving heats it up and seals the deal.  

Another method is to patch the hole.  For this, your tire has to first be taken off the vehicle, then off the rim so the technician can get access to the inside. There, they’ll clean the inside surface around the hole and apply a rubber patch with an adhesive on it. This type of patch works well, and because of the extra steps and complexity, costs more than having your tire plugged.  

There’s also a combination of those methods just described, the plug-patch.  It is, in essence, a type of patch with glue on it that has a plug sticking out of it.  The plug is inserted into the tire from the inside and pulled through the hole from the outside, drawing the attached patch tight against the tire’s inside surface. The last two methods can’t be used if the hole is near another repair or the sidewall.    

The good news is if it’s fixed properly, your repaired tire should give you good service.

High-Tech Auto and Truck Center
4007 Westfax Drive
Chantilly, VA 20151
7039686648
http://high-tech-auto.com